Aventi — Freestanding Parcel Letterbox

Install and use your Aventi with this quick, no-nonsense guide.

Tools Required

• Hammer drill
• 10 mm masonry drill bit
• Spirit level

Choose a Location

Pick an easily accessible spot for couriers and deliveries.

Installation on Existing Concrete

1. Position the letterbox where you want it and mark the mounting point with a pencil.
2. Drill a 10 mm diameter hole to approximately 70 mm depth.
3. Realign the letterbox over the drilled hole and secure it using the expansion bolt (see “Mounting the Expansion Bolt”).

Installation on Ground (New Slab)

1. Excavate a hole approx. 43 cm (W) × 39 cm (L) × 10 cm (D).
2. Fill with concrete.
3. Level the surface with a spirit level and allow it to fully cure.
4. Place the letterbox on the slab and mark the mounting hole.
5. Drill a 10 mm diameter hole to approximately 70 mm depth.
6. Realign the letterbox and fix it with the expansion bolt (see below).

Mounting the Expansion Bolt

1. Ensure the nut on the expansion bolt is loose.
2. Insert the bolt through the base hole into the concrete.
3. Gently tap down until fully seated.
4. Tighten the nut firmly using the supplied tube spanner.

How to Use Aventi

Deliveries via Top Parcel Chute

Accepts parcels up to 35 × 33 × 24.5 cm. Parcels rest on a floating floor that drops into the lower compartment when the lid is closed, then resets when opened to prevent access to the retrieval area.

Deliveries via Lockable Lower Door

For larger items up to 34.5 × 32.5 × 55 cm (e.g., a box of wine), couriers can open the front door with your combination, place the parcel inside, close the door, and re-set the combination.

Tip: Add delivery instructions when ordering. Example: “Place in letterbox. Use code 321 to open.”

Resetting the Combination Lock

Important: Do not release the reset button until your new code is fully set and memorised.

1. Set the lock to the current unlock code (factory default may be 0-0-0) and turn to OPEN.
2. Find the small reset hole on the lock side. Insert a pin to locate the spring-loaded reset button. If you can’t feel it, rotate the lock fully (clockwise or anticlockwise) and try again.
3. Press and hold the reset button.
4. While holding, set your new code by rotating the dials.
5. Release the reset button to save the code.
6. Test the new code several times before closing the door.

Support

DAGOOD Letterboxes — 3/169 Queens Road, Kingston QLD 4114
sales@dagood.com.au · dagood.com.au